The Influence of Two Cylinder Diesel Engine Modification (IDI to DI) on Its Performance and Emission
Modification of combustion system from indirect injection (IDI) to direct injection (DI) was carried out on the two cylinder diesel engine, followed with tests for performance and emission. The modification from IDI to DI was conducted on a two cylinder diesel engine by removing the pre-chamber from the inside of the cylinder head, replacing the injector and its position to the top of the combustion chamber directly and also replacing the original piston with a piston that has a bowl on the crown. Performance and emission tests were conducted on 1,500 rpm with loads that vary from 0, 10, 20, 30, 40, 50, to 60 Nm. The investigation results of the diesel engine modification from IDI to DI showed several interesting phenomena. Further research is needed in order to increase the engine performance and reduce its emission.
J. Huang, et al., "Experimental study of the performance and emission characteristics of diesel engine using direct and indirect injection systems and different fuels," Fuel Processing Technology, vol. 92, pp. 1380-1386, 2011. crossref
M. Gomaa, et al., "Trade-off between NOx, Soot and EGR rates for an IDI diesel engine fuelled with JB5," World Academy of Science, Engineering and Technology, vol. 38, p. 6, 2010. crossref
A. Nur, "Pengaruh pergeseran waktu injeksi terhadap performa dan opasitas motor diesel," presented at the Semnas Teknik Mesin 3, 2008.
W.-J. Lee, et al., "Assessment of energy performance and air pollutant emissions in a diesel engine generator fueled with water-containing ethanol–biodiesel–diesel blend of fuels," Energy, vol. 36, pp. 5591-5599, 2011. crossref
L. Xing-cai, et al., "Effect of cetane number improver on heat release rate and emissions of high speed diesel engine fueled with ethanol–diesel blend fuel," Fuel, vol. 83, pp. 2013-2020, 2004. crossref
H. Permana, "Beberapa pengetahuan dasar mengenai mesin diesel," Buletin ITP, vol. II, pp. 25-29, 1996.
F. J. Wallacae, "The theory of compression ignition engine," in Diesel engine reference book, B. Challen and R. Baranescu, Eds., 2nd ed Oxford: Butterworth-Heinemann, 1999, pp. 3-26.
C. D. Rakopoulos, et al., "Study of combustion in a divided chamber turbocharged diesel engine by experimental heat release analysis in its chambers," Applied Thermal Engineering, vol. 26, pp. 1611-1620, 2006. crossref
K. B. Binder, "Diesel engine combustion," in Handbook of diesel engine, K. Mollenhauer and H. Tschoeke, Eds., 1st ed Heidelberg: Springer Verlag, 2010, pp. 61-75. crossref
A. Nur, et al., "The Effect of Ethanol-Diesel Blends on The Performance of A Direct Injection Diesel Engine," Mechatronics, Electrical Power, and Vehicular Technology vol. 03, pp. 49-56, 2012. crossref
ISO, "Reciprocating Internal Combustion Engine-Performance," vol. 3046-3, ed: ISO, 2006.  ISO, "General Competence of Testing and Calibration," vol. 17025, ed: ISO, 2005.
ISO, "Reciprocating Internal Combustion Engines-Exhaust Emission Measurement," vol. 8178-1, ed: ISO, 2006.
W. W. Pulkrabek, Engineering fundamentals of the internal combustion engine. New Jersey: Prentice Hall, 1997.
J. B. Heywood, Internal combustion engine fundamentals; Chapter 10: Combustion in Compression-Ignition Engines. New York: McGraw-Hill, 1988.
J. V. Gerpen, "Diesel combustion and fuels," in Diesel engine reference book, B. Challen and R. Baranescu, Eds., 2nd ed Oxford: Butterworth-Heinemann, 1999, pp. 90-104.
J. B. Heywood, Internal combustion engine fundamentals; Chapter 3: Thermochemistry of Fuel-Air Mixtures. New York: McGraw-Hill, 1988.
ACL ENGINE MANUAL No. 413, 1st ed. Waterloo: Gregory's Scientific Publications, 1991.
R. C. Engineer, "Exhaust emissions,? in Diesel engine reference book," in Diesel engine reference book, B. C. a. R. Baranescu, Ed., ed Oxford: Butterworth-Heinemann, 1999, pp. 473-483.
Metrics powered by PLOS ALM
- There are currently no refbacks.